Need some help? Check out our new Help Centre

Guitar engraving

edited September 2015 in Project Showcase
The guitar project is coming along well and I wanted a record of how it was built.
So...........

I engraved the AutoCAD file onto the back.

It's 2.5mm thick bamboo, engraved at 1500mm per minute, 100% power.
I love the level of detail, on the lettering on the headstock that says TPKR3-N the stem of the T is 0.25mm wide !!

Edit: Would help if I added the right photo :(

Comments

Sign In or Register to comment.