It looks like you're new here. If you want to get involved, click one of these buttons!
News and Announcements
General Emblaser Discussion
General Software Discusson
Tips & Tricks
Mods / R&D
Need some help? Check out our new
Cut2D and PiCLaer Lite in one project
Work in progress, the photo is 350mm x 280mm and took four hours to produce. The header and footer were a lot more straightforward. Inlays are bamboo, frame is clear pine.
Was the frame routed out to take the panels?
edited July 2015
Yep, I should have used rounded rectangles rather than overcutting the corners but not too fussed. It is for a mates band to display when they are playing pub gigs. I am going to do another version in engraved acrylic then LED edge lit for night gigs.
Excellent job David!
Powered by Vanilla