Need some help? Check out our new Help Centre

Future Upgrades:

@darklylabs: Can you consider to have the following upgrades/features for the Emblaser:
1. Ability to save the settings based on the material being cut (Vectric)
2. Some mechanism to move the laser up and down rather than push/pull by hand (like a threaded stud so as to be able to fine tune height more easily)
3. Any chance that the 6W+ NUBM44 diode could be used with the Emblaser?

These are just some suggestions that I feel would help to better the Emblaser.

Joel.
Sign In or Register to comment.