Need some help? Check out our new Help Centre

Converting vector files to NC files

Hi guys, I'm struggling to find a programme that can convert the likes of AI and DXF files to NC format so that I can load them into the universal GCoder system to etch )it only seems to accept input from NC files).

picLaser allows me to convert entire images, but it doesn't seem to support basic vectors so it literally draws the entire page, from point A to point Z.

cut2D allows me to open the AI and DXF but doesn't allow me to export them into NC format.

Any advice as to either how to convert the more common files to NC or on how to run the more common files through the GCoder instead?

Regards
Peter

Comments

Sign In or Register to comment.