It looks like you're new here. If you want to get involved, click one of these buttons!
News and Announcements
General Emblaser Discussion
General Software Discusson
Tips & Tricks
Mods / R&D
Need some help? Check out our new
Picsender include in PicEngrave Pro 5 + Laser ?
If I buy PicEngrave Pro 5 + Laser, must I buy Picsender after for the best result ?
PicSender is not required, but is recommended. There are open source gcode streamers available such as UGS, GRBL Panel and ChiliPeppr. If your laser engravings will be small in size, then these streamers have been known to work.
PicSender was developed alongside the EmBlaser for streaming very large, fast changing raster engraving gcode files reliably to it. It has been tested to 10,000,000 lines of gcode.
thank you very much for all informations.
Powered by Vanilla