Need some help? Check out our new Help Centre

Please help, line out of allign

edited September 2015 in Archived Issues
i have try when moving left and right, top down, i have noticed that when i change direction left and right (for step of 1inch for instance), there's a slight movement in top/down direction about 1~2mm, how to fix this. please help.

attached the video and the Emblaser_VectorTest result
https://www.dropbox.com/s/09nb04uemqr95ax/IMG_1517.MOV?dl=0

Comments

  • This could be for one of the following reasons:

    1: A motor pulley is slipping on the motor shaft.
    2: The belt tension is not correct. Possibly too loose.
    3: The gantry is not aligned correctly.
    4: A belt is not routed correctly over the idler pulleys.
Sign In or Register to comment.