Need some help? Check out our new Help Centre

Extra Fan

Could I use a 12v spitter between the power brick and the emblaser to run a extra fan or would that take to much power away from the emblaser?

Comments

  • Hi Lewis

    I'm not exactly sure but the Power supply is a 12V 3A output supply so I think if you have 3W for the laser, this equals at 12V about 350mA, the Motors have a power of about 5W each which is about 450mA so the total power is about 1500mA so I think there is plenty power left for a small 12V fan.

    But maybe wait for a official response from Darklylabs

    Dominic
  • Thank you for your response Dominic, I'm thinking I should just buy the bits I'm after, try them and see the out come.
Sign In or Register to comment.