It looks like you're new here. If you want to get involved, click one of these buttons!
News and Announcements
General Emblaser Discussion
General Software Discusson
Tips & Tricks
Mods / R&D
Need some help? Check out our new
Any idea why the test file might miss the very start (bottom left corner) and the very end (letter D)?
This happens when your laser power is just on the verge of cutting a material. In certain areas the cutting does not begin because of a direction change or slightly different reflective property of the material in that area.
There are two possible solution for this:
1: Your focus is not optimal. Take your time and run tests with your focus setting 1/4 to 1/2 turn in either direction to see whether this improves.
2: Your feed-rate is too high for this material or your power is too low. Try slowing it down slightly to find the right balance between feed-rate and laser power.
Powered by Vanilla